Daytona AC 4 WD motorcycle shoes

The AC4 WD:
+ material mix of smooth leather and textile
+ elastic, pleasantly soft shaft edge
+ textile lining (100% polyester)
+ laces
+ donning aid (a loop at the back of the shaft)
+ ankle protection on both sides
+ padded on the inside of the ankle with open-cell special foam
+ abrasion-resistant PU shift reinforcement
+ climate insole, anatomically shaped
+ thanks to plastic-reinforced inner sole with hot-dip galvanised steel insert, particularly torsion-resistant and yet easy to roll
+ non-slip wedge rubber sole

Naturally, motorbike boots are there for motorcycling. But they should also be suitable for a short stroll through the old town or to the ice cream parlour or the way to work. However, not everyone likes the stable hold of a high boot shaft on these metres. This is where the AC4 WD comes in handy – a boot whose shaft only reaches the ankle. WD stands for „walk and drive“ the boot shows its good sides both when walking and driving.
It is easy to put on: The pull-on aid, a loop at the heel, makes sure of that. The entry is very comfortable and is closed with the boot's lacing. Many proven Daytona qualities can be seen down the ankle: The ankle protection on both sides and the elastic, soft shaft edge provide support and are comfortable at the same time. The switch reinforcement is abrasion-resistant, the insole is reinforced with plastic and is particularly torsion-resistant thanks to a hot-dip galvanised steel insert. If you take a few steps while trying them on, you'll notice it right away: the stable sole is nevertheless easy to roll on and also slip-resistant off-road.